ICP DAS WISE User Manual
http://wise.icpdas.com
77
After all settings of the DI channels are completed, continue the
configuration of other channels, and after all channel settings are
completed, click “OK” button to save the changes and return to
Modbus RTU Module List.
Please Note: For M-7000 modules, the counting mode of the DI
channel counter is Falling. You can change the counting mode by
DCON Utility
6.5.2 The DO channel setting for ICP DAS module
The ICP DAS Modbus RTU module DO channel setting interface is
shown as below (using M-7060 as an example):
Figure 6-32
:
ICP DAS Modbus RTU module DO Channel Setting page
The settings are as below:
Nickname: For user to define nickname for the module and the
I/O channels, these nickname will be displayed on the “Channel
Status” and “Rule Setting” pages.
For DO channels, WISE provides the “Auto OFF” and “DI Status
Mapping” advanced functions, please refer to ”
channel setting for I-7000/DL DCON module
” section for detail.
After all settings of the DO channels are completed, continue the