ICP DAS USA TouchPAD VPD-173X-64, Быстрый старт

Страница: 3 / 8

Technical support: service@icpdas.com P3
3
Rotary Switch & Default Settings
The definition of the rotary switch:
No Mode Description
0
Run &
Update
(Ethernet)
This is a special run mode which is used in
the development stage. The TouchPAD
device can be updated by a PC from the
remote side through Ethernet.
(Default)
1
Ethernet
Force
Update
While the application run on the TouchPAD
device seriously crashes, use this mode to
update a new application to the TouchPAD
device through Ethernet.
2 Run Only Run the program.
9
USB Force
Update Update a new application to the TouchPAD
device through USB.
Network Default Settings
IP Address 192.168.255.1
Subnet Mask 255.255.0.0
Gateway 192.168.0.1
4
First Use of the VPD-173X Series
1. Connect wires as the below figure
or prepare an Ethernet cable which
will be used to supply power through
PoE if there’s a RJ-45 Ethernet port
on it. And set the rotary switch to 0
(At this point, the power is not yet
supplied).
Use a flat-head screwdriver to set
rotary switch
PoE Switch
GND
VDC (+12-+48 V)
External Power