P7
8. Learn IR Commands
In the section
“Test and Save Learned IR Commands”
of the IR utility:
(1) Select the item in “Device Name” and “Command Name” combobox.
(2) Click “Learn On” button to enable IR learning mode (TR/LN LED is
ON).
(3) Aim the emitter head of the remote control (RC) to the “IR Input” hole
on the module (distance less than 3 cm) and press the remote control
button which is to be learned in a short time. After IR learning is
finished, the TR/LN LED is OFF.
(4) Select IR Output 1 in the output channel combobox.
(5) Aim the IR emitter, which is plugged in IR Output 1 jack, to the IR
receiver of the controlled device. Click “Run Command” button to
check the effectiveness of the IR learning command. Repeat (2) and
(3) if no action on the device.
(6) Click “Save this Cmd” button.
(7) Repeat the above (1)~(6) to finish IR learning.
Besides, the color rectangle (marked a blue dotted frame) means:
➢
Red: Learning data is saved in the item of “Command Name”.
➢
Yellow: Get learning data form IR module. The data is buffered and
lost when selecting other item of “Command Name”.
➢
White: No learning data saved in the current item of “Command
Name”.
2
4
6
5
1
距離：
≤
3 cm
遙控器
2
3
