CAN-2018C Quick Start Ver. 1.1, Feb/2014
1
CAN-2018C Quick Start
Hardware Specification
CAN Interface
CANopen Specification
CiA DS-301 v4.02, DS-401 v2.1
No. of PDOs
10 Rx, 10 Tx (Support dynamic PDO)
PDO Mode
Event-triggered, Remotely-requested, Cyclic and acyclic SYNC
Node ID
1~99 selected by rotary switch
Baud Rate (bps)
10k, 20k, 50, 125k, 250k, 500k, 800k and 1M
Error Control
Node Guarding protocol and Heartbeat Producer protocol
Terminator Resistor
Switch for 120 Ω terminator resistor
Connector
5-pin screwed terminal block
(CAN_GND, CAN_L, CAN_SHLD, CAN_H, CAN_V+)
Analog Input
Channels
8
Input Type
+/- 15mV, +/- 50mV, +/- 100mV, +/- 500mV, +/- 1V, +/- 2.5V
+/-20mA (Requires Optional External 125 Ohms Resistor)
Thermocouple (J, K, T, E, R, S, B, N, C)
Resolution
16-bit
ESD Protection
+/-4 kV, Contact for each channel
LED
Status LED
PWR LED, RUN LED, ERR LED
Power
Input range
Unreg10 ~ +30 V
DC
Power Consumption
1.5 W
Environment
Operating Temp.
-25 ~ 75
℃
Storage Temp.
-30 ~ 80
℃
Humidity
10 ~ 90% RH, non-condensing
For more information about CAN-2018C, please visit the following website:
http://www.icpdas.com/products/Remote_IO/can_bus/can-2018c.htm