iCool TWIN, Руководство пользователя

Страница: 5 / 14

06 iCool Sport
STEP 3
STEP 4
Connect the plug from the filter pumps to the
socket on the rear panel of the iCool Twin
Check that all connections are to the correct side of the iCool Twin
If you are operating 2 pools make sure that both the hoses and the
filter pump’s power cable for each pool are connected to the same side
of the iCool Twin. Connect the LEFT side pool’s hoses and filter pump
power cable to the to the LEFT side of the iCool and the RIGHT side
pool’s hoses and filter pump power cable to the RIGHT side of the iCool,
looking from the back.
Connect Electric Power
Connect the power cable supplied with your iCool to a standard power
outlet capable of providing at least 12 amps in countries with a 220
V supply and 24 amps in countries with a 110 V supply. Although the
system requires much less power than this during normal operation,
all heat pump compressor motors need considerably more power for a
minute or so each time they starts up.
Your System Software will begin loading
Your iCool TWIN has a TWO full colour high-resolution touch screens
that eliminate all switches and provide complete control over all of your
iCool’s systems in a user-friendly and intuitive manner.
It also provides a substantial amount of additional information to assist
you. When you turn on the power for the first time the system will load
the latest software from its memory and run a diagnostic self test
routine. This will take about 20 seconds. During this time you will see
this screen (shown at right) and then a BLACK screen.
The System Status Bars will flash white
The STATUS BARS on each side at the front of the iCool Twin will change
colour or flash to give a clear indication of each function. The left one is
for the left side heat pump and the right side for the right hand heat pump.
Main Power Switch
The main power switch is also part of the ELECTRICAL SAFETY CIRCUIT that guards against the possibility of electric shock. Every electric
component in the iCool is protected by this device. It is a good idea to test this system each time you use the iCool by turning on the main switch
and then pressing the test button above the switch. If the safety system is working normally, pressing the test button will cause the main power
switch to shut down instantly.
Reset the main switch to ON to begin normal operation. If it does not shut down instantly when you touch the test button do not use the iCool
until the fault is found and corrected by a trained person.
WARNING
For safety, the power outlet you use must be earthed correctly
The Software Loading Screen
Pool 2 Pool 1