15
35
36
38
37
34.
Remove the preattached 90mm Pulleys (78)
from the Double “U”-bracket (62).
Wrap the Butterfly Cable (69) under a 90mm Pulley
(78). Attach the Pulley and a pair of Pulley Covers
(8) to the Double “U”-bracket (62) with an M10 x
50mm Bolt (100) and an M10 Nylon Locknut (87).
Make sure the small tabs on the Pulley Covers
are on the top.
35. Wrap the Butterfly Cable (69) over a “V”-pulley (55).
Attach the Pulley and a Cable Trap (102) to the
other side of the bracket on the Butterfly Upright (3)
with an M10 x 60mm Bolt (59) and an M10 Nylon
Locknut (87).
Make sure that the Cable Trap is
turned to hold the Cable in the groove of the
Pulley.
36. Attach the Butterfly Cable (69) to the Pivot Bracket
(70) on the Right Butterfly Arm (26) with an M8 x
20mm Shoulder Bolt (103) and an M8 Nylon
Locknut (34).
37.
Locate the Leg Lever Cable (75), which is
2398mm long and has an eyelet on one end and
a threaded pin on the other end. Route the eyelet
end of the Cable through the Seat Upright (9) and
attach it to the tab on the Leg Lever (10) with an
M8 x 20mm Shoulder Bolt (103) and an M8 Nylon
Locknut (34).
38. Attach a 90mm Pulley (78) inside of the Seat
Upright (9) with an M10 x 65mm Bolt (18), two M10
Washers (91), two 12mm Spacers (89), and an M10
Nylon Locknut (87), as shown.
69
55
69
103
59
102
87
75
78
87
18
9
89
89
91
91
3
34
75
10
9
103
70
26
34
34
69
78
68
68
87
62
100
Small
Tab
