19
51. Route the Right Stack Cable (70) down through
the Right Top Frame (7) and over a 90mm Pulley
(39). Attach the Pulley and a Small Cable Trap
(48) inside the Top Frame with an M10 x 80mm
Bolt (111), two M10 Washers (116), a 19mm
Spacer (77), a 16mm Spacer (124), and an M10
Nylon Locknut (114).
Make sure the 16mm
Spacer and the Small Cable Trap are on the
same side of the Pulley.
52. Set an M12 Washer (129) on top of the Long
Weight Tube (36). Thread an M12 Nut (128) all
the way onto the Right Stack Cable (68).
Thread the Right Stack Cable (68) into the Long
Weight Tube (36). Tighten the M12 Nut (128)
against the M12 Washer (129).
53.
Locate the Press Cable (69).
Grease an M8 x
86mm Shoulder Bolt (86). Attach the Cable to the
Leg Press Frame (12) with the Bolt, an M8
Washer (117) and an M8 Nylon Locknut (115).
54. Wrap the Press Cable (69) around a 90mm
Pulley (39). Attach the Pulley, two Half Finger
Guards (42), a Small Cable Trap (48), and an
M10 Washer (116) to the Left Seat Frame (10)
with an M10 x 103mm Bolt (106), an M10 Washer
(116), and an M10 Nylon Locknut (114).
Make
sure the Cable Trap and Finger Guards are
oriented as shown.
55. Wrap the Press Cable (69) around a “V”-pulley
(40). Attach the “V”-pulley, two Half Finger Guards
(42), and two M10 Washers (116) to the Leg
Press Frame (12) with an M10 x 118mm Bolt
(100), an M10 Washer (116), and an M10 Nylon
Locknut (114).
Make sure the Finger Guards
are oriented as shown.
51
124
116
116
114
111
77
68
7
48
39
52
68
36
128
129
53
117
115
12
69
86
54
114
116
116
106
10
69
42
42
48
39
55
116
116
116
100
114
12
40
69
42
42
Grease
