ICON STAGE USER MANUAL
2
1. SAFETY INSTRUCTIONS
1.1. IMPORTANT SAFETY WARNING
This device has left the factory in perfect condition. In order to maintain this condition and to ensure safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written
in this user manual.
In order to install, operate, and maintain the lighting fixture safely and correctly we suggest that the
installation and operation be carried out by qualified technicians and these instructions be carefully
followed.
CAUTION!
HIGH VOLTAGE. RISK OF SEVERE OR FATAL ELECTRIC SHOCK
CAUTION!
ALWAYS DISCONNECT MAINS SUPPLY BEFORE REMOVING ANY FIXTURE COVERS
CAUTION!
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE. SENSITIVE PERSONS MAY SUFFER
AN EPILEPTIC SHOCK
CAUTION!
NEVER TOUCH THE DEVICE DURING OPERATION! COVERS MAY BE HOT
CAUTION!
KEEP THIS DEVICE AWAY FROM RAIN AND MOISTURE
Important:
Damage caused by the disregard of this user manual is not subject to warranty. The dealer
and manufacturer will not accept liability for any resulting defects or problems.
1) If the device has been exposed to temperature changes due to environmental conditions, do
not power on immediately. The resulting condensation could damage the device. Leave the
device powered off until it has reached room temperature.
2) This device falls under protection-class I. Therefore, it is essential that the device be earthed.
3) If either lenses or display are damaged (damage may include cracks or gashes in the material)
they must be replaced.
4) Electrical connections, such as replacing the power plug, must be performed by a qualified
person.
5) Make sure that the available voltage is not higher than that which is stated at the end of this
manual.
6) Make sure the power cord is never crushed or damaged by sharp edges. (If the Power cord
suffers from this case, the cable must be replaced by an authorized dealer.)
7) If the external flexible power cord of this device is damaged, it shall be exclusively replaced by
the manufacturer or their service agent or a similar qualified person in order to avoid injury.
8) When the device is not in use or before performing maintenance, always disconnect the device
from the mains. Only handle the power cord from the plug. Never pull the plug out of a socket
by tugging the power cord.
9) When powered on for the first time, some smoke or smell may occur. This is caused by the
coating on the metal parts when it is heated. And it is normal. If you are concerned, please
contact your distributor.
10) Do not focus the beam onto flammable surfaces. The minimum distance between the exiting