ICON PRO-FORM MX 640, Руководство пользователя

Страница: 8 / 30

8
2b
B
116
PULSE
Jack
If you purchase the optional heart rate monitor (see
page 19), follow the steps below to install the receiver in-
cluded with the heart rate monitor.
1. Make sure that the power cord is unplugged. Remove
the six or seven indicated Screws (46) from the back of
the Console Base (116).
2. Connect the Short Jumper Wire (A) to the wire on the
Receiver (B). Connect the other end of the Jumper Wire
to the PULSE jack on the back of the Console (see draw-
ing 2b). Next, peel the paper off the pad on the back of
the Receiver. Turn the Receiver so the cylinder is on
the side shown, and press the Receiver into the bottom
of the Console Base (116) in the location indicated by the
dotted line. Note: A long jumper wire is included but will
not be used.
Make sure that no wires are pinched. Reattach the
back of the Console Base (116) with the Screws (46) (see
step 1 above).
116
46
1
A
Cylinder
2a
7. Refer to drawing 7a. Locate the left Rear Foot (59) on
the treadmill. If the left Rear Foot touches the floor, go to
step 8. If there is a space between the left Rear Foot and
the floor, follow the instructions below.
Hold the treadmill firmly with both hands, and raise the
treadmill to the storage position as described on page
20.
Refer to drawing 7b. Using a phillips screwdriver, remove
the Screw (60), the right Rear Foot (59), and the Rear
Foot Spacer (11) from the treadmill. Reattach the right
Rear Foot without the Rear Foot Spacer. Hold the tread-
mill with both hands, and lower the treadmill as
described on page 21.
Check the left Rear Foot (59 [see drawing 7a]). If the left
Rear Foot is still off the floor, raise the treadmill and re-
move the left Rear Foot. Snap the Rear Foot Spacer (11)
onto the left Rear Foot and reattach the left Rear Foot
and the Rear Foot Spacer. Carefully lower the treadmill.
59
11
60
7a
7b
59
8. Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a
secure place. The allen wrench is used to adjust the walking belt (see page 23). To protect the floor or carpet
from damage, place a mat under the treadmill.