1
PART #
DESCRIPTION
97721EP
21-23 F150 4WD TREMOR REAR 2.5 AL VS
PB CDEV PAIR
97721EP INSTALLATION INSTRUCTIONS
1.
Using a properly rated jack, raise the rear of the vehicle and support
the frame rails with jack stands. Ensure the jack stands are secure and set
properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED
VEHICLE.
COMPONENTS INCLUDED
(2) 194801E-AL 21-23 F150 4WD TREMOR REAR
2.5 AL VS PB CDEV UPKG
HARDWARE INCLUDED
(8) 257164 HEIM SPACER COM10 SPACER X .500
X 1.500 CZINC
(2) 255604-26 EXTENSION HARNESS COIL 26 FT
TOOLS REQUIRED
JACK
JACK STANDS
PRY BAR
TORQUE WRENCH
15MM SOCKET / WRENCH
18MM SOCKET / WRENCH
TECH NOTES
1. ESTIMATED INSTALL TIME: 1-2 HOURS,
2. YOUR ICON SHOCK ASSEMBLIES COME FACTORY CHARGED TO 150 PSI. RELEASING NITROGEN
PRESSURE MAY LEAD TO SHOCK MALFUNCTION AND REDUCED RIDE QUALITY. FAILURE CAUSED BY
LOW NITROGEN PRESSURE IS NOT COVERED UNDER ICON’S WARRANTY POLICY.
8-9-2023 REV.A
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON | Fax: 951.689.1016
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLATION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
INSTALLATION
2.
Remove the factory rear shocks using a 15mm and
an 18mm socket/wrench.
[FIGURE 1]
FIG.1
