3
15.
Install the reservoir mount and sway bar relocation block. Using the supplied socket head, bolt the block to the frame with the
reservoir mount sandwiched between the relocation block and frame as shown. The heads will be recessed in the block. Make sure the
block is positioned so that the new threaded holes are forward of the countersunk holes. Using the supplied (605100) bolts, (605133)
washers and factory U-clamp, reinstall the sway bar in it’s new position, forward of factory location.
[FIGURE 5 & 6]
16.
(KDSS ONLY)
On KDSS equipped vehicles there is a tab located on the driver side frame rail of the vehicle. This tab will need to
be cut off to allow for installation of the shock reservoir bracket (154005).
[FIGURE 7]
17.
(KDSS ONLY)
For vehicles equipped with Kinetic Dynamic Suspension System, each remote reservoir bracket will be mounted
using two (605144) self-tapping bolts.
18.
(KDSS ONLY)
Hold the reservoir mounting bracket against the frame and mark the location of the hole on the lower part of the
frame.
19.
(KDSS ONLY)
Move the reservoir mounting bracket away from the frame and drill an 11/32” hole in the center of the spot that you
just marked.
20.
(KDSS ONLY)
Deburr the hole, place the reservoir and mount back against the frame, and install the self-tapping bolts.
21.
Mount reservoir according to diagram for appropriate year and model. The lower hose clamp goes through the slot in the bracket
and the upper registers in the notches at the top of the bracket. Position the reservoir so the clamp bands are in the recessed groove
on the can and secure.
[FIGURE 8 & 9]
FIG.6
FIG.5
FIG.9
FIG.7
FIG.8
2010+ FJ / 4RUNNER
RESERVOIR MOUNTING
2007-2009 FJ /
2005+ TACOMA
RESERVOIR
MOUNTING
2007-2009 FJ /
2005+ TACOMA
BRACKET MOUNTING
2010+ FJ /
4RUNNER
BRACKET
MOUNTING
