Page 3
For technical questions, please call 1-888-866-5797.
Item 58118
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note:
The Bearing Separator comes fully assembled.
Jaw Puller
1. Choose appropriate size Yoke and
Jaws for object being removed:
• Use same size Clamp Bolt and Yoke.
• Use the same size Jaws on each side.
• Jaws should be just long enough to
fit around object being pulled.
Note;
Connect Jaws to same holes that best
fit the size of the object being pulled.
2. Attach one Jaw to Yoke using a Jaw Pin.
Attach Jaw pointing in for external pulling
or pointing out for internal pulling.
Jaw Pin
Yoke
Jaw
3. Insert the Clamp Bolt through the Jaw opening
and hand tighten Washer and Nut.
4. Attach the other Jaw, Washer and Nut.
Clamp Bolt
Washer
Nut
5. Thread the Pressure Screw through the Yolk
and through the groove in the Clamp Bolt
.
Pressure
Screw
6. Thread appropriate Pressure Tip into
the end of the Pressure Screw.
Pressure
Tip