1
PART #
DESCRIPTION
27821EP
18-UP JL 2.5” LIFT FRONT REMOTE
RESERVOIR 2.5 CDEV SHOCK PAIR
27821EP INSTALLATION INSTRUCTIONS
WARNING!
** READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH
BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE
NOT PROPERLY FOLLOWED SEVERE FRAME, SUSPENSION AND TIRE
DAMAGE MAY RESULT TO THE VEHICLE!
** ICON VEHICLE DYNAMICS RECOMMENDS THAT YOU EXERCISE
EXTREME CAUTION WHEN WORKING UNDER A VEHICLE THAT IS
SUPPORTED WITH JACK STANDS.
** ICON VEHICLE DYNAMICS RECOMMENDS ALL INSTALLATION TO
BE PERFORMED BY A PROFESSIONAL SHOP/SERVICE TECHNICIAN.
PRODUCT FAILURE CAUSED BY IMPROPER INSTALLATION WILL NOT BE
COVERED UNDER ICON’S WARRANTY POLICY.
1.
Using a properly rated jack, raise the rear of the vehicle and support the frame rails with jack stands. Ensure the jack stands are
secure and set properly before lowering the jack. NEVER WORK UNDER AN UNSUPPORTED VEHICLE. Remove the rear wheels.
2.
Remove the factory front shock using a 18mm.
[FIGURE 1]
3.
Using factory hardware, install the 2.5” front shocks with the long spacers towards the frame. Shocks are labeled DRVR & PASS.
Use a 18mm and torque to factory spec.
[FIGURE 2]
COMPONENTS INCLUDED
(1) 124953ED 18+ JL 2.5” LIFT FRONT REMOTE
RESERVOIR 2.5 CDEV SHOCK DRVR
(1) 124953EP 18+ JL 2.5” LIFT FRONT REMOTE
RESERVOIR 2.5 CDEV SHOCK PASS
(1) 120050D 18+ JL JT RESI MOUNT DRVR
(1) 120050P 18+ JL JT RESI MOUNT PASS
(1) 120052D 18+ JL JT RESI HEAT SHIELD DRVR
(1) 120052P 18+ JL JT RESI HEAT SHIELD PASS
(1) 611051 STAINLESS HOSE CLAMP KIT
HARDWARE INCLUDED
(18) 605004 #10 SAE FLAT WASHER
(6) 605036 10-32 X .500 BUTTON HEAD SCREW
(6) 605042 10-32 NYLOCK NUT
(4) 605144 3/8-12 X .75 FLANGED SELF TAPPING
SCREW
ADDITIONAL COMPONENTS
(1) 255604-04 4-FT WIRE
(1) 255604-10 10-FT WIRE
TOOLS REQUIRED
FLOOR JACK
OSCILLATING SAW
TORQUE WRENCH
11/32 DRILL BIT
CENTER PUNCH
1/8” ALLEN
3/8” SOCKET / WRENCH
5/16” SOCKET / WRENCH
9/16” SOCKET / WRENCH
18MM SOCKET / WRENCH
TECH NOTES
1. THIS SHOCK REQUIRES AT LEAST 1” OF BUMPSTOP SPACER TO AVOID DAMAGE.
2. YOUR ICON SHOCK ASSEMBLIES COME FACTORY CHANGED TO 150 PSI. RELEASING NITROGEN
PRESSURE MAY LEAD TO SHOCK MALFUNCTION AND REDUCED RIDE QUALITY. FAILURE CAUSED BY
LOW NITROGEN PRESSURE IS NOT COVERED UNDER ICON’S WARRANTY POLICY.
3. WIRE LENGTHS ARE MEASURED FOR A 3.6L V6 4 DOOR.
INSTALLATION
7929 Lincoln Ave. Riverside, CA 92504
Phone: 951.689.ICON | Fax: 951.689.1016
FIG.1
FIG.2
7-22-2022 REV.B
