1. It is the responsibility of the owner to ensure
that all users of the stepper are adequately
informed of all precautions.
2. Use the stepper only as described.
3. The stepper is intended for home use only.
Do not use the stepper in a commercial,
rental, or institutional setting.
4. Place the stepper on a level surface. Cover
the floor beneath the stepper to protect the
floor or carpet.
5. Inspect and properly tighten all parts often.
Replace any worn parts immediately.
6. Keep children under the age of 12 and pets
away from the stepper at all times.
7. Keep hands and feet away from moving parts.
8. Always wear appropriate clothes, including
athletic shoes for foot protection, when using
the stepper.
9. Always keep your feet on the pedals when
stepping and be careful not to lose your bal-
ance. It is recommended that you place the
stepper near a wall or a chair for support.
10. The resistance cylinders become very hot
during use. Allow the resistance cylinders to
cool before touching them.
11. Make sure that the cable remains on the pul-
ley. If the cable binds, stop exercising and
make sure that the cable is on the pulley.
12. If you feel pain or dizziness at any time whilst
exercising, stop immediately and cool down.
WARNING:
Before beginning this or any exercise program, consult your physician. This
is especially important for persons over the age of 35 or persons with pre-existing health problems.
Read all instructions before using. ICON assumes no responsibility for personal injury or property
damage sustained by or through the use of this product.
WARNING:
To reduce the risk of serious injury, read the following precautions and all
instructions in this manual before using the WESLO
®
Mini Stepper.
Important Precautions
1. Plug the Reed Switch Wire (8) into the jack on the
back of the Monitor (7). Push the excess Reed
Switch Wire down into the Mounting Cap (17).
Slide the Monitor onto the tab on the Mounting
Cap, being careful to avoid pinching the Reed
Switch Wire. IMPORTANT: If there is a sheet of
clear plastic on the Monitor, remove it. Make
sure to keep liquids away from the Monitor and
keep the Monitor out of direct sunlight.
INSTALLING BATTERIES
The monitor requires two 1.5V “AA” batteries. Slide
the monitor off the mounting tab (see drawing 1 at the
left). Remove the battery cover from the back of the
monitor. Insert two batteries into the monitor, with the
negative (–) ends of the batteries touching the
springs. Reattach the battery cover. Make sure that
the reed switch wire is plugged into the jack on the
back of the monitor, and carefully slide the monitor
back onto the mounting tab. IMPORTANT: Make sure
to remove the batteries when storing the stepper.
MONITOR OPERATION
1. To turn on the monitor, press either of the buttons
on the monitor or begin stepping.
2. To start the monitor, press the ST/STOP button.
The STOP indicator will disappear from the dis-
play. As you step, the monitor will display the total
number of steps you have completed and the
elapsed time. To stop the monitor, press the
ST/STOP button again. The STOP indicator will
reappear.
3. To reset the monitor, press the RESET button.
4. To turn off the monitor, simply stop exercising. If
the pedals are not moved and the buttons are not
pressed for a few minutes, the monitor will turn off
to conserve the batteries.
Assembly
Using the Stepper
7
1
8
Tab
17
2. Raise both Pedal Arms (12, 13) to the position
shown. Insert the shaft on the U-bracket (24) into
the round tube on the Base (1). Route the Cable
(22) around the Pulley (23). Push down the Pedal
Arms, making sure that the Cable remains around
the Pulley.
12
13
24
22
2
23
WESLO is a registered trademark of ICON Health & Fitness, Inc.
2
3
Thank you for selecting the new WESLO
®
Mini
Stepper. Stepping is one of the most effective exercises
for increasing cardiovascular fitness, building
endurance, and toning the body. The compact
WESLO
®
Mini Stepper lets you enjoy this exercise in
the convenience of your own home.
For your benefit, read this manual carefully before
using the Mini Stepper. If you have questions after
reading this manual, please call our Customer Service
Department at 08457 089 009. To help us assist you,
please mention the product model number
(WLEMSM15920) when calling.
Before You Begin
