7
2. Remove the M10 Nut (33), the M10 x 50mm Bolt
(4), and the shipping bracket (C) from the Base
(85). Attach a Wheel (86) with the Bolt and the
Nut that you just removed.
Do not overtighten
the Nut; the Wheel must turn freely.
Discard
the shipping bracket.
85
4
33
C
2
86
1.
Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.
Remove and discard the two indicated bolts (A)
and the shipping bracket (B).
Cut the shipping tie securing the Upright Wire
(77) to the Base (85). Locate the plastic tie in the
indicated hole in the Base, and use the plastic tie
to pull the Upright Wire out of the hole.
Attach a Base Foot (81) to the Base (85) in the
location shown with a Base Foot Spacer (104)
and an M4.2 x 25mm Tek Screw (2). Then, at-
tach a Base Foot (81) in the location shown with
only an M4.2 x 25mm Tek Screw (2).
85
2
48
81
1
81
2
77
Hole
104
B
A
