31
SYMPTOM: The treadmill will not connect to the
wireless network
a.
Make sure that the wireless settings on the console
are correct (see page 26).
b.
Make sure that the settings for your wireless net-
work are correct.
c.
If you still have questions, go to support.iFit.com.
SYMPTOM: The displays of the console do not
function properly
a.
If the console does not boot up properly, or
if the console freezes and does not respond,
reset the console to the factory default settings.
IMPORTANT: Doing this will erase all the
custom settings you have made to the console.
Resetting the console requires two people. First,
press the power switch into the off position. Next,
locate the small reset opening (A) on the back
edge of the console. Using a bent paper clip (B),
press and hold the reset button inside the opening,
and have a second person press the power switch
into the on position. Continue holding the reset
button until the console turns on. When the reset
operation is complete, the console will turn off and
then turn back on. If it does not, use the power
switch to turn the treadmill off and then on again.
Once the console turns on, check for
fi
rmware
updates (see HOW TO USE THE MAINTENANCE
SECTION on page 25). Note: It may take a few
minutes for the console to be ready for use.
SYMPTOM: The walking belt slows when walked on
a.
Use only a surge suppressor that meets all of the
speci
fi
cations described on page 16.
b.
If the walking belt is overtightened, treadmill per-
formance may decrease and the walking belt may
become damaged. Remove the key and
UNPLUG
THE POWER CORD.
Using the hex key, turn both
idler roller screws (C) counterclockwise, 1/4 of a
turn. When the walking belt is properly tightened,
you should be able to lift each edge of the walking
belt 2 to 3 in. (5 to 7 cm) off the walking platform.
Be careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and walk on
the treadmill for a few minutes. Repeat until the
walking belt is properly tightened.
c.
Your treadmill features a walking belt coated with
high-performance lubricant.
IMPORTANT: Never
apply silicone spray or other substances to
the walking belt or the walking platform unless
instructed to do so by an authorized service
representative. Such substances may deterio-
rate the walking belt and cause excessive wear.
If you suspect that the walking belt needs more
lubricant, see the front cover of this manual.
d.
If the walking belt still slows when walked on, see
the front cover of this manual.
a
A
B
C
C
2–3 in.
b
Содержание NordicTrack T 6.5 Si
Страница 5: ...5 all STANDARD SERVICE PLANS...
