31
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even while
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, first unplug the power
adapter.
Next, see assembly step 16 on page 15. Using a
standard screwdriver, remove the Shield Cover (75)
and the Shield Cover Cap (118).
Next, see assembly step 15 on page 15 and
remove the Right Upper Body Leg Outer and Inner
Covers (69, 83).
Then, see assembly step 12 on page 13 and
remove the Right Pedal Arm (58) from the Right Upper
Body Leg (60).
Remove the M8 x 16mm Screw (95), the Large Axle
Cover (53), and the M8 Washer (not shown) from the
right Crank Arm (20). Then, carefully remove the Right
Roller Arm (59) and the Right Pedal Arm (58) from the
elliptical.
See EXPLODED DRAWING C on page 39. Identify
the Left and Right Shields (73, 74). Remove the
M4 x 19mm Screws (5) and the M4 x 48mm Screw
(107) from the Left and Right Shields. Then, remove
the Right Shield.
Next, locate and loosen the Idler Screw (89). Tighten
the Belt Adjustment Screw (91) until the Drive Belt
(113) is tight. Then, retighten the Idler Screw.
Reattach the parts that you removed. Then, plug in the
power adapter.
59
20
95
58
53
113
91
89
