Page 8
7 Specification & Features
(Typical conditions @ 235v 50Hz)
300B output valves
4x 6SN7 (CV181) double triodes
Low, medium and Zero feedback options
Icon designed and manufactured Tertiary wound
output transformers
Hand wired point to point components
No printed circuit board
Ceramic valve bases for low noise/leakage
32W maximum output 8 Ohms
25W maximum output 8 Ohms (Lower HT mode)
Signal to noise level -88dB
Freq. response 20Hz -0.2dB to 20kHz -0.5db 8w
0.3% THD at 8 watts
Channel balance typically less than 0.1 dB
4 and 8 ohms output taps
Choke regulated power supply
Supplied
valve
cover
Audiophile quality metal film resistors
SCR Audiophile polypropylene audio caps
Optional Mundorf capacitor upgrade
Japanese ALPS volume pot.
Rubicon/Nichichron
power
caps.
Internal wiring using PTFE silver plated cable
Valves carefully matched for best performance
Gold plated Input & speaker terminals
Line level Inputs for CD, Tuner, Aux, etc
Record loop with monitor switch
140, 300, 790mv sensitivity options
230-240volts 50 Hz for EU and UK countries
117v 60Hz for USA Canada
50 W Standby 150w 0 signal. 235 Watts max
IEC SKT T3.15A (T5A 117V) fuse (with spare)
Internal HT fuse 315ma T ceramic. (2x spares)
380W, 220H, 380D mm Amp overall 25kg
Carton= 55x53x38cm 30kg packed
IEC mains lead
Conforms to CE ROHS and WEEE where applicable
Specification subject to change without notice.
*
RMS watts
Do not literally exist! But this figure is based upon the RMS
voltage output (V²/R) to indicate continuous output as opposed to “peak”
output which is mis-leading.
*Triode
a simple valve with only 3 elements, this gives very linear
amplification. Some “pentode” (5 element) valves can also be wired to act as
“pseudo” triode valves (not in this amplifier).
