Icom ID-5100A, Основное руководство

Страница: 57 / 108

New2001
44
4
D-STAR OPERATION
4
D-ST
AR OPERA
TION
PROBLEM POSSIBLE CAUSE SOLUTION REF.
After your call, the repeater re-
plies ‘RPT?’ and call sign of the
destination repeater. • The repeater cannot connect to the destina-
tion repeater.
• The repeater is busy.
• Check the repeater setting.
• Wait for a while, and try it again.
—
—
After your call, the access re-
peater replies ‘RPT?’ and its call
sign. • The call sign of the destination repeater is
wrong.
• Correctly set the destination repeater call
sign.
—
Even holding down [DR], the DR
screen will not appear.
• There is no repeater list in your radio. • Reload the repeater list using the SD card.
• Enter the Repeater list data directly into the
transceiver.
p. 51
Section 7 of the
Full Manual
Even holding down [RX>CS], the
received call sign will not set to
the destination call sign.
• The call sign has not been correctly re-
ceived.
• When a received signal is weak, or a signal
is received during scanning, the call sign
may not be received correctly. In that case,
“--------” appears and error beeps sound,
and a reply call cannot be made.
• Try it again, after the transceiver has cor-
rectly received the call sign.
—
A Local area call can be made,
but the Gateway call or destina-
tion station call cannot be made. • MY call sign has not been registered at a
D-STAR repeater.
• Register your call sign (MY) on a D-STAR
repeater, or confirm the registration of the
call sign.
p. 27
“L” appears on the LCD, and the
received audio is interrupted. • While receiving through the internet, some
packets may be lost due to a network error
(poor data throughput performance).
• Wait a while, and try it again.
When the transceiver receives corrupted
data, and misidentifies it is as packet loss,
“L” is displayed, even if it is a Local area
call.
—
“DV” and “FM” icons alternately
blink. • While in the DV mode, an FM signal is re-
ceived.
• Wait a while, and try it again. Section 7 of the
Full Manual