This service manual describes the latest service information
for the IC-RX7 WIDEBAND RECEIVER at the time of
publication.
NEVER connect the receiver to an AC outlet or to a DC
power supply that uses more than specifed. This will ruin
the receiver.
DO NOT expose the receiver to rain, snow or any liquids.
DO NOT reverse the polarities of the power supply when
connecting the receiver.
DO NOT apply an RF signal of more than 20 dBm (100 mW)
to the antenna connector. This could damage the receiver’s
front-end.
To upgrade quality, any electrical or mechanical parts and
internal circuits are subject to change without notice or
obligation.
MODEL
VERSION
RX FREQUENCY RANGE (MHz)
IC-RX7
[EUR01]
0.150–1300.000
[UK-01]
[USA-01]
0.150–821.995
851.000–866.995
896.000–1300.000
[EXP-01]
0.150–1300.000
[CHN-01]
[CAN-01]
Be sure to include the following four points when ordering
replacement parts:
1. 10-digit Icom parts numbers
2. Component name
3. Equipment model name and unit name
4. Quantity required
TA31136FNG IC-RX7
MAIN UNIT
5 pieces
IC-RX7
Top cover
10 pieces
Addresses are provided on the inside back cover for your
convenience.
Icom, Icom Inc. and
logo are registered trademarks of Icom Incorporated (Japan) in the United States, the United
Kingdom, Germany, France, Spain, Russia and/or other countries.
ORDERING PARTS
1. Make sure that the problem is internal before
disassembling the receiver.
2. DO NOT open the receiver until the receiver is
disconnected from its power source.
3. DO NOT force any of the variable components. Turn
them slowly and smoothly.
4. DO NOT short any circuits or electronic parts. An
insulated tuning tool MUST be used for all adjustments.
5. DO NOT keep power ON for a long time when the
receiver is defective.
6. READ the instructions of test equipment throughly
before connecting a test equipment to the receiver.
REPAIR NOTES
INTRODUCTION
CAUTION
UNIT ABBREVIATIONS:
L=LOGIC
UNIT
M=MAIN
UNIT
