Icom IC-M605E, Инструкция по эксплуатации

Страница: 116 / 126

New2001
106
New2001
TROUBLESHOOTING
14
New2001
PROBLEM POSSIBLE CAUSE SOLUTION REF.
The transceiver does
not turn ON.
• Bad connection to the power supply.
• Blown fuse.
• Check the connection to the transceiver
and power supply.
• Repair the problem, and then replace
the fuse.
p. 94
p. 96
Little or no sound
comes from the
speaker.
• Squelch level is set too high.
• Volume level is set too low.
• The internal speaker is OFF.
• Set the squelch to the threshold point.
• Set the volume to a suitable level.
• Turn ON the internal speaker.
p. 18
p. 18
p. 87
You cannot transmit,
or cannot select high
power.
• Some channels are set for low power or
receive only by regulations.
• The output power is set to low.
• Change channels.
• Push [HI/LO] to select high power.
pp.14,108
p. 18
Scan does not start. • More than 2 favorite channels are not set. • Set the Favorite channels. pp.23,90
No beep sounds. • The Key Beep function is OFF. • Turn ON the Key Beep function. p. 85
The Main screen is not
displayed at power ON.
• MMSI (DSC self ID) code is not set. • Set the MMSI (DSC self ID) code. p. 9
Individual or Group ID
cannot be set.
• The entered ID code is incorrect.
First digit must be set to between ʻ1ʼ and
ʻ9ʼ for an Individual ID.
First digit must be set to ʻ0ʼ for a Group ID.
• Enter a correct ID code. pp.25,26
“??” blinks instead of
the position and time.
• 4 hours have passed since you manually
entered the position.
• The GPS position is invalid.
• Enter the position. p. 27
“NO POSITION”
and “NO TIME” are
displayed instead of
the position and time.
• The GPS antenna is not correctly
connected.
• The position and time have not been
manually entered.
• Check the GPS antenna connection.
• Enter the position and time.
p. 94
p. 27