7
REMOTE CONTROL OPERATION
1
D
D
RF Power (High) (
0008 Default)
This command is available from both the transceiv-
er and phone line. This explanation shows the oper-
ation from the transceiver when entering the pass-
word and command continuously or step by step
operation from the phone line (one after the other).
This command cannot be performed while repeater
is transmitting, therefore you must stop the repeater
operation before changing RF power.
[From the transceiver]
q
Enter the following DTMF code from the trans-
ceiver.
Code:
∗
0001#0004#
• Verify the repeater replies “OK ACK (3333).”
• If the repeater replies “NG ACK (4040),” make sure
the password, header tone, de-limiter tone and
Repeat Stop code are correct, and try again.
e
Enter the “RF Power (High)” command within 10
sec.
Code:
∗
0008#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗
0001#0008#
).
• The repeater changes transmit power Low to High.
r
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗
0001#0003#
).
[From the Phone line]
q
Dial the phone number of the phone line that the
repeater is connected to.
w
When the connection has been confirmed, enter
the programmed password.
Code:
∗
0001#
• Verify the repeater replies “System Password OK
ACK (1111).”
• If the repeater replies “NG ACK (4040),” make sure
the password, header tone and de-limiter tone are
correct, and try again.
e
Enter the “Repeat Stop” command within 10 sec.
Code:
∗
0004#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗
0001#0004#
).
r
Enter the “RF Power (High)” command within 10
sec.
Code:
∗
0008#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗
0001#0008#
).
• The repeater changes transmit power Low to High.
t
Enter the “Repeat Start” command within 10 sec.
Code:
∗
0003#
• Verify the repeater replies “OK ACK (3333).”
• If the 10 sec. input standby time runs out, enter the
password and command continuously (Code:
∗
0001#0003#
).
y
Hang up the phone, the repeater automatically
disconnects the phone.
OPERATION EXAMPLE (Continue)
