8
2
OPERATION
D
D
Direct code entry
q
While in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
• Code digit for editing blinks.
w
Push [TX Code Enter] to select the desired digit to be edited.
• Digit for editing differs according to the setting.
e
Set the desired digit using [
]/[
].
r
Push [TX Code Enter] to set the digit, then the digit to the right
will blink automatically.
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and “WAIT” is
displayed during each call. However, an error beep sounds
and “FAILED” is displayed when no answer back is received
after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [P3] (Moni(Audi)) to send the “Clear down” signal.
For your information
When the ‘UpDate’ setting for the call code is enabled, the set code
is overwritten into the call code memory.
! OG_BIIS_IC-F50V_0.qxd 07.8.8 6:19 PM Page 8 (1,1)
