Icom IC-F3061T, Инструкция по эксплуатации

Страница: 13 / 36

9
2
PANEL DESCRIPTION
2
EMERGENCY KEY
“
EMR
”
Push and hold for a specified period to transmit an emer-
gency call.
• If you want to cancel the emergency call, push (or push and hold)
the key again before transmitting the call.
• The emergency call is transmitted one time only or repeatedly until
receiving a control code depending on the pre-setting.
SURVEILLANCE KEY
“
SURV
”
Push to turn the surveillance function ON or OFF.
When this function is turned ON, the beep is not emitted and
the LCD backlight does not light when a signal is received or
a key is pushed, etc.
TX CODE CHANNEL SELECT KEY
“
TXC
”
Push to enter the ID code channel selection mode directly.
Then set the desired channel using [CH Up]/[CH Down].
(p. 15)
TX CODE CHANNEL UP/DOWN KEYS “
TXCU
” “
TXCD
”
Push to select a TX code channel directly.
SCRAMBLER FUNCTION
“
SCR
”
Push to toggle the voice scrambler function ON and OFF.
COMPANDER KEY “
COMP
”
Push to toggle the compander function ON and OFF.
The compander function reduces noise components from
the transmitting audio to provide clear communication.
PHONE KEY
“
PHN
”
Push to connect or disconnect the telephone network con-
nection during LTR operation.
USER SET MODE KEY
“
SET
”
➥
Push and hold to enter user set mode.
• During user set mode, push this key to select an item, and
change the value or condition using push [CH Up]/[CH Down].
➥
Push and hold this key again to exit user set mode.
User set mode is also available via the ‘Power ON function.’
Refer to (p. 16) also.
OPT OUT KEYS
“
OP1
” “
OP2
” “
OP3
”
Push to control the output signal level of the optional ports in
the optional unit connector.
OPT MOMENTARY KEYS
“
O1M
” “
O2M
” “
O3M
”
Push and hold to control the output signal level of the option-
al ports in the optional unit connector.
TALKGROUP KEY
“
TGID
”
While in the digital mode operation, push to enter the talk-
group ID selection mode. Then select the desired talkgroup
ID using [CH Up]/[CH Down].
TX STATUS KEY “
TXST
”
While in the digital mode operation, push to enter the Status
message selection mode. Then select the desired Status
message using [CH Up]/[CH Down].