Icom IC-F3030 Series, Инструкция по эксплуатации

Страница: 14 / 40

9
3
BASIC OPERATION
■
Channel selection
Several types of channel selections are available. Methods
may differ according to your system set up.
NON-ZONE TYPE:
Push [CH Up] or [CH Down] to select the desired operating
channel in sequence.
Push one of [MR-CH 1] to [MR-CH 4] keys to directly select a
channel.
ZONE TYPE:
Push [Zone], then push [CH Up] or [CH Down] to select the
desired zone.
AUTOMATIC SCAN TYPE:
Channel setting is not necessary for this type. When turning
ON the transceiver, the transceiver automatically starts
scanning. Scanning stops when receiving a call.
■
Call procedure
When your system employs tone signaling (excluding CTCSS
and DTCS), the call procedure may be necessary prior to voice
transmission. The tone signaling employed may be a selective
calling system which allows you to call specific station(s) only
and prevent unwanted stations from contacting you.
q
Select the desired TX code channel or 2-Tone code
according to your System Operator’s instructions.
• This may not be necessary depending on programming.
• Refer to page 11 for selection.
w
Push the call key (assigned to one of the dealer
programmable keys: [Emer], [Side1], [Side2], [Side3],
[P0], [P1], [P2] and [P3]) or [PTT].
e
After transmitting a 2-Tone code, the remainder of your
communication can be carried out in the normal fashion.
Selective calling Non-selective calling