Icom IC-92A, Инструкция по эксплуатации

Страница: 58 / 144

Ne
52
7
DV MODE OPERATION (Optional UT-121 is required for IC-92A)
New2001
■
Message operation
D
TX message programming
TX messages are available for up to 5 channels and each
channel can be programmed with a message of up to 20
characters. Available characters are
0 to 9 , A to Z
(capital let-
ters)
, a to z
(lower case letters)
, some symbols and space.
q
Enter “TX MESSAGE” in message/position set mode.
• TX MESSAGE screen is displayed.
w
Rotate [DIAL]
†
to select the desired transmit message
channel.
• Ch01 to Ch05 and OFF are available.
• Previously message is displayed if programmed.
e
Push [ ](6) to select the message edit condition.
• The 1st digit of the message blinks.
r
Rotate [DIAL]
†
to select the desired character or symbol.
• Push [A/a](3) to change the character group from “AB” (alpha-
betical characters; capital letters), “ab” (alphabetical characters;
lower case letters), “12” (numbers) and “-!”-” (symbols) in se-
quence.
• If an un-necessary character is entered, push [ ](6) or [ ](4)
to select the character, then push [CLR](1) to erase the se-
lected character, or push and hold [CLR](1) for 1 sec. to erase
all characters following the cursor.
t
Push [ ](6) to select 2nd digit, then rotate [DIAL]
†
to se-
lect the desired character or code.
• Push [ ](6) to move the cursor right; push [ ](4) to move the
cursor left.
• 2nd digit blinks (1st digit stops blinking).
y
Repeat the steps
r
and
t
to enter the desired message.
• Up to 20-character messages can be set.
u
Push [ ](5) to store the message.
i
Push [MENU/ ] to return to frequency indication.
❮
MENU screen
❯
➪
❮
MESSAGE/POSITION
❯
➪
❮
TX MESSAGE
❯
(Push [MENU/ ] ) (Rotate [DIAL]
†
, then push [ ](5)
†
.)
Ch01 Ch01
†
:SET :SET :SEL :SEL
:BACK :BACK
CLR:CLR CLR:CLR
TX MESSAGE
:EDIT :EDIT
r
Ch01 Ch01 !''
Hello!
†
:SET :SET
:SEL
:SEL
:CUR
:CUR
CLR:CLR
A/a:CHAR
A/a:CHAR
TX MESSAGE
r