7-2
7
MEMORY OPERATION
MEMORY
CHANNEL
MEMORY
CHANNEL
NUMBER
CAPABILITY
COPY
TO VFO
OVER-
WRITING
CLEAR
Regular memory
channels
1–199
Independent transmit and receive frequencies
and mode in each memory channel.
Yes
Yes
Yes
Scan edge
memory channels
P1, P2
One frequency and mode in each memory chan-
nel to use as scan edges for a programmed
scan.
Yes
Yes
No
The transceiver has 201 memory channels, including
2 scan edge channels.
The Memory mode is very useful to quickly select of-
ten-used frequencies.
All 201 memory channels are tuneable, which means
the programmed frequency can be tuned temporarily
by rotating
[DIAL], even in the memory mode.
■
About the Memory channels
■
Selecting Memory channels
Push
q
V/M
➔
to select the Memory mode.
• “
” appears.
Rotate
w
[M-CH] to select the desired memory chan-
nel.
• If the RIT control indicator lights orange, push
M-CH/RIT
SET
to turn OFF the RIT and set the
[M-CH] control to
memory channel control. (See details below.)
• All memory channels, including blank channels, can be
selected.
• Pushing
[UP]/[DN] on the microphone also selects the
memory channels. Only programmed memory chan-
nels are selectable using the microphone buttons.
About the [M-CH] control:
When the RIT control indicator lights orange, the
memory channels cannot be selected by rotating
the
[M-CH] control because the [M-CH] control
acts as the RIT control.
In this case, push
M-CH/RIT
SET
to set the
[M-CH] con-
trol to memory channel control (RIT control indica-
tor goes out).
[M-CH]
RIT control
indicator
[EXAMPLE]: Selecting memory channel 17.
VFO mode
Memory mode
Channel 17 is selected.
Lower channels
Higher channels
RIT control indicator
goes out
[EXAMPLE]: Selecting memory channel 17.
VFO mode
Memory mode
Channel 17 is selected.
[EXAMPLE]: Selecting memory channel 17.
VFO mode
Memory mode
Channel 17 is selected.
Push
V/M
➔
Rotate
[M-CH]
Previous view
