Icom IC-410PRO, Основное руководство

Страница: 9 / 20

4
2
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
■
Receiving and transmitting
NOTE:
Transmitting without an antenna may damage the
transceiver.
1. Receiving
If “TSQL” or “TSQL
ë
” is displayed, you can only receive
calls from others with the same tone squelch code.
Select the desired operating channel.
➥
Push [UP]/[DOWN].
• Push [MONI] to turn the Monitor function ON or OFF.
2. Transmitting
1) Check for a clear channel, or wait until a conversation is
completed before transmitting.
2) While holding down [PTT], speak into the microphone at
your normal voice level.
Information
To maximise the clarity of the signal:
• Pause briefly after pushing [PTT]. This ensures that the first part of
your message is transmitted.
• Hold the microphone about 5 to 10 cm from your mouth.
Transmit inhibit function
The transceiver will not transmit under the following
conditions.
• The channel is busy.
• The displayed channel is a receive only channel.
(Example: CB22, CB23)
Output power level
Depending on the operating environment, it is useful to
reduce or increase the transceiver output power level of the
transceiver.
1) Enter the Set mode.
➥
Hold down [FUNC] for 2 seconds.
2) Select the “RFPOW” menu.
➥
Push [FUNC] until the “RFPOW” menu is displayed.
3) Select “HI” or “Lo.”
➥
Push [UP]/[DOWN].
4) Exit the Set mode.
➥
Hold down [FUNC] for 2 seconds.