Icom CY-F121S, Инструкция по эксплуатации

Страница: 7 / 21

■
Repeater Controller
Programming Mobile Radios
➀
Transmitter:
• Go to LMR>Memory CH>Free, Program the
TX and RX to the transmit frequency
• Set the CTCSS/CDCSS Tone
• Set RF Power to High
• Go to LMR>Common>Expert, Set EPTT/ • Go to LMR>Common>Expert, Set EPTT/ • Go to LMR>Common>Expert, Set EPTT/
FTSW to EPTT (to allow ExtPTT)
* Inside the TX radio, Short jumper D and solder
TXData to F
➁
Receiver:
• Go to LMR>Memory CH>Free, Program the RX
frequency
• Set the CTCSS/CDCSS Tone
• Enable TX inhibit
• Set RF Power to LOW2
• Go to LMR>Common>Expert, set RX EXO to ON
(to enable Signal HORN, CSQ, and PL/DPL)
CABLE CONNECTORS
X1 Accessory Connector TX
X2 Accessory Connector RX
X3 FAN
X4 J6 Optional Connector RX
X5 J6 Optional Connector TX
JP2 Repeater Disable
JP3 Transmit On
JP4 Hang On Time
JP5 Hang On Time
JP6 Hang On Time
JP7 Hang On Time
JP8 Audio On
JUMPER SETTINGS
JP7 JP6 JP5 JP4 T sec.
1 1 1 1 0
0 1 1 1 0.5
1 0 1 1 1
1 0 1 1 1.5
1 1 0 1 2
0 1 0 1 2.5
1 0 0 1 3
0 0 0 1 3.5
1 1 1 0 4
0 1 1 0 4.5
1 0 1 0 5
0 0 1 0 5.5
1 1 0 0 6
0 1 0 0 6.5
1 0 0 0 7
0 0 0 0 7.5
HANG ON TIME CONFIGURATION
** 1 = ON; 0 = OFF
PANEL DESCRIPTION 1
4