The harness has 2 positions. The straps should go into the
nearest slots above the height of the child's shoulders. To
adjust the harness, remove each strap by passing it through
the slots from the front to the back of the seat; re-route the
straps through the appropriate slots. If the shoulder height is
not suitable. Please re-install the seat again.
NO-Too low
7
ADJUSTING THE SHOULDER HEIGHT BEFORE
THE CAR SEAT WILL BE INSTALLED IN THE CAR
NO-Too high
YES-Correct
THE HARNESS
Step
C
.
Always check that the harness is correctly locked by
pulling above and below the buckle
. (Fig
3
)
Caution!
Tighten the straps until they are in contact with your
baby's body. The hip belt must lie as low as possible over your
baby's hips.
Step D.
The harness should be adjusted as tightly as possible
without causing discomfort to the child. A loose harness is
dangerous and should be checked each time that you use the
seat. To tighten the harness, pull down on the pull strap until
the harness is the correct tightness. (Fig 4)
C
aution!
Pull on the pull straps until the harness lies flat and
is contact with your child's body. Pull the strap straight. There
should never be more than one finger's width of space between
the shoulder straps and your child's shoulders.
Step E.
The harness is loosened by pulling on both shoulder
straps at the same time. (Fig 5)
UNFASTENING THE HARNESS
To release the harness, push the red button in the middle of the
harness buckle. You can now release the harness and lift your
child from the seat; ensure that the buckle connectors do not
catch on clothing
