IR-PAD SERIES USER MANUAL
18
IF YOU DO NOT USE THE IMAGER FOR A LONG PERIOD OF TIME, PUT THE
DEVICE IN A COOL AND DRY ENVIRONMENT. THE BATTERY WILL DISCHARGE
OVER TIME; THEREFORE, THE IMAGER SHOULD BE CHARGED OCCASIONALLY
TO PREVENT DAMAGE TO THE BATTERY OR THE DEVICE.
8-1 How to Charge the Battery
Before using the imager for the first time, charge the battery for a minimum of
5 hours. The battery status is shown by the indicator in the upper-right corner
of the screen.
8-1-1 Charging via Power Adapter
1.
Plug the power cord into the power adapter.
2.
Plug the power adapter cable into the IR-Pad Series charge port.
3. Plug the power adapter into a 110v/120V electrical outlet.
ENSURE THE IMAGER IS NEAR ROOM TEMPERATURE BEFORE CHARGING THE
DEVICE. DO NOT CHARGE IN EXTREMELY HOT OR COLD AREAS. THE BATTERY
CAPACITY MAY BE DECREASED IF CHARGED IN AN EXTREME TEMPERATURE
ENVIRONMENT.
THE THERMAL IMAGER NEEDS SUFFICIENT WARM-UP TIME FOR THE MOST
ACCURATE TEMPERATURE MEASUREMENTS AND BEST IMAGE QUALITY.
THIS TIME CAN OFTEN VARY BY ENVIRONMENTAL CONDITIONS. IT IS BEST
TO WAIT A MINIMUM OF 10 MINUTES FOR THE DEVICE TO COMPLETELY
WARM-UP.
8-2 Power On/Off the Device
To turn the camera on, push the Power button. Please wait patiently as it can
take several minutes for system to boot up.
To power off the device, shut down any running programs, including IR-Flash Pro;
then, select the Start button followed by the Power button. Choose Shut down
from the available power options. Sleep mode is not available on the device.
To restart the device, shut down any running programs, including IR-Flash Pro;
then, select the Start button followed by the Power button. Choose Restart from
the available power options.
8.
Operation Instructions
