REFERENCE DIAGRAM
04
05
DRIVER SIDE example
below:
Rear:
Front:
ICI STEP INSTALLATION
Step 1 (Prep)
Beginning on the Driver's side,
remove any steps if equipped.
Next, locate the 3 sets of
mounting points on the
underside of the vehicle.
Please note that your vehicle
may have tape, plugs, and/or
factory bolts covering up the
mounting locations. These will
need to be
removed so that the
mounting locations can be
accessed. Keep any OE
hardware to reuse during
installation.
Figure 1.
Step 3 (Hang bar
on Brackets)
Next, locate the driver side bar
,
the distance from the front of
the bar to the first step hoop is
greater than the distance from
the rear of the bar to the
second step hoop, reference
the diagram on page
6
.
The top
of the bar has a
small lip, use
the lip to hang the
bar on the
brackets. This will
make the
installation process
easier and
hands-free.
Figure 2.
Step 2 (Install
Brackets to
Jeep
)
Begin with the driver front bracket
100529
, loose fit
. For the 2 pinch
weld holes, you will need (2 sets) of
M6x25mm hex head bolt
s,
M6
Nylock Nuts, and (
2
) of M6x22x2mm
flat washers. Use a 10mm socket.
For the floorboard hole, you will
need (1 set) of M8x28x3mm flat
washer, M8 lock washers, and
M8x35mm hex head bolts. Use a
13mm socket. Once the front
bracket is attached, move on to the
middle bracket, then the rear
bracket, repeating the steps above.
Figure
3
.
100529
100530
100531
