ICI STEP INSTALLATION
Step 1 (Prep)
Beginning on the Driver's side,
remove any steps if equipped.
Next, locate the 3 sets of
mounting points on the
underside of the vehicle (Fig. 1).
Please note that your vehicle
may have
factory OE plastic
bolts
covering up the mounting
locations. These will need to be
removed so that the mounting
locations can be accessed.
ICI STEP INSTALLATION
Figure 1.
Step 3 (Hang bar
on Brackets)
Next, locate the driver side bar
.
T
he
front half of the bar has
four bolt holes while the rear
half of the bar has three bolt
holes
, reference
figure 3
.
The
top of the bar has a
small lip,
use the lip to hang the
bar on
the brackets. This will
make the
installation process
easier and
hands-free.
Figure 6.
Figure 5.
04
05
Figure 2.
Step 2 (Install
Brackets to
Tacoma
)
Begin with the driver front bracket
1005
32
.
Use
(2 sets)
of M8x
3
0mm
hex bolts
,
M8
flat washers
, and
M8
l
ock
w
ashers.
Use a 13mm
socket
and do not fully tighten
yet. Once the front bracket is
attached, move on to the middle
and rear
bracket
s (100533)
,
repeating the steps above
for
each bracket
.
Figure
4.
Figure
3
.
Step 4 (Bolt Middle
Bracket to Bar)
Start by bolting the middle
bracket (1005
33
) to the bar.
Use
(2 sets)
of M8
nylock nuts
,
M8x3
5
mm
hex countersunk
bolts
, M8 flat washers, and
M8
finish washers. Use a
13mm wrench and the
provided Allen wrench. Do
not fully tighten until all
brackets and steps have been
attached.
Step 5 (Bolt Bar to
Front Bracket and
Rear Bracket
)
Next, bolt the bar to the front
bracket (1005
32
).
Do not fully
tighten
yet
.
Use
(2 sets)
of M8
nylock nuts, M8x3
5
mm
hex
countersunk bolts
, M8 flat
washers, and M8 finish
washers.
Use a 13mm wrench
and the provided Allen
wrench.
Repeat the steps
above for the rear bracket
(100533)
See the diagram on
page 3 for reference.
Step 6 (
Bolt Front
and Rear Hoop
Steps to bar
)
After the brackets have been
attached to the bar, bolt the
front
and rear
hoop step to the
bar. For
each hoop step
,
use
(2
sets) of
M8 nylock nuts,
M8x3
5
mm
hex countersunk
bolts
, M8 flat washers, and M8
finish washers. Use a 13mm
wrench and the provided Allen
wrench.
Leave loosely fitted for
now.
