ICI STEP INSTALLATION
STEP
8
(Tighten
Bracket
s
to
4Runner
)
Make sure all 3 brackets, the
bar, and the 2 hoops steps are
loosely fitted to each other
and to the vehicle. Using a 12
or 13mm socket, fully tighten
the front bracket to the
vehicle, make sure the bracket
is flush with the mounting
surface. Repeat on the middle
and rear bracket checking the
bracket alignment as needed.
STEP
9
(Tighten
Brackets to the Bar
and Hoop-Steps)
N
ow, ad
j
ust the bar from
front to back and tighten the
bar to the brackets with a
13mm socket and provided
Allen. Make sure the bar is
flush with the front and
bottom face of the brackets
as you are tightening them
.
0
6
Figure
9
.
0
7
STEP
7 (Bolt Bar to
Rear Bracket and
Hoop Step)
Repeat steps
5
and
6 f
or the
rear bracket and hoop step.
As shown in Figure 7, t
he rear
bracket and hoop step share a
bolt in the very rear.
See the
diagram on page 3 for
reference.
ICI STEP INSTALLATION
www.facebook.com/InnovativeCreationsInd
www.instagram.com/ici_usa
Hashtags:
#ICIUSA
#ICIAlumilite
#AlumiliteSteps
#AlumiliteBumpers
Figure
7
.
Figure
8
.
Figure
10.
STEP 10 (Finish)
Check all hardware and
make sure they are fully
tightened. Reference
diagram on page 3 for
hardware locations. Repeat
Steps 1-
10
for the Passenger
Side.
*PRO TIP:
When tightening the Finish Washers, hold the Allen
K
ey tight so the
B
olt does not spin.
Then, ti
ghten the
N
ut on the backside.
This will prevent the
B
olt and
F
inish
W
asher from spoinning and scratching the
B
ar.
AMAZING
!
You have successfully completed the
installation
of your new Alumilite s
teps
.
Time
to flex on your friends through
Social Media! Don't forget to Tag us!
Drop us a Review!
