icetro ID-0450-AN, Руководство пользователя

Страница: 20 / 32

20
We Think of Customer Satisfactio
n
6. Required Actions to prevent frost
If the ambient temperature falls below 0℃, water will freeze inside the machine and machine
operation will be impossible.
If you do not use for a long period of time in winter, be sure to completely remove the ice making
water inside the body by following the instructions below. If you do not remove the ice making
water or if it is insufficient, it will cause serious damage to the product.
This shall not be guaranteed by the manufacturer and may result in a lot of repair costs.
Please observe the following points.
Caution
1. Turn on the power switch and press the
DOWN + SET button at the same time for
3 seconds with any signal on the FND window.
Forced drainage will be done for 30 seconds.
2. Turn off the power switch and disconnect the power
plug from the outlet.
3. Remove the upper panel → the back panel.
(However, it does not work in full text.)
4. Remove the evaporator cylinder drain hose clamp
and remove the hose, and wait until the ice in the
evaporator cylinder completely melts down.
(It is possible to remove internal water quickly by
using compressed air gun etc.)
5. Reassemble the evaporator cylinder drain hose and tighten the clamp.
6. Assemble in the order of back panel → upper panel
Water Removal in Water Tank and Evaporator
Power
switch
UP button
DOWN
button
SET
button
FND display window
ICE MAKING-
OFF-WASH switch
When the water in the front drain is full, a white float comes up, so take out the drain
to the front and pour water.
(If water overflows, it may flow into the store floor, so empty it from time to time).
Empty the drainage gutter