CONTROL PANEL:
ON/OFF: Press the button to turn the unit on or off.
ADD WATER: This light will turn on, accompanied by a beeping sound, when the water level is too
low. Add water to the reservoir and press the ON/OFF button to restart the machine.
ICE FULL: This light will turn on , accompanied by a long beep, when the ice basket is full. Remove
the ice and press the ON/OFF button to restart the ice maker.
HOW TO OPERATE:
1. Open the lid and fill the water tank with fresh water. NOTE: Make sure the water level in
the water tank is not over the ice basket.
2. Close the top lid and connect the ice maker to the power.
3. Press ON/OFF button on the control panel to begin the ice making cycle.
4. The machine normally produces 9 cubes of ice with each batch. The first batch will take
approximately 20 minutes. After that, it takes around 10 minutes for each batch. Note that
the first three batches might be small and irregular in size.
5. Regularly check the “Add Water” indicator as the machine will automatically turn off if the
water pump cannot inject water, and the indicator will be on.NOTE: if no water is pumped up
to the water tray over two cycles, but there is enough water in the water tank, unplug the
silicone stopper and let several drops of water run out. Restart the unit.
6. When the ice basket is full, the “Ice Full” indicator will turn on. Remove some ice with the
scoop and restart the unit.
7. Press ON/OFF button to stop the machine.
4
