8
Now fit the lower hinge assembly using the pre-drilled holes on the lower
left hand side of the cabinet and fit the foot to the r-hand side
Remove the plastic caps from the top left hand side and refit them into
the holes on the top right hand side
Remove the plastic cap from the top left hand side of the door and refit
into the hole on the top right hand side
Position the door onto the lower hinge assembly and refit the upper hinge
assembly .
Ensure that the door is correctly aligned and sealed, then tighten all the
screws and refit the upper hinge cover
4.6. What to do if something goes wrong
There is no power to the appliance:
Check there is not a power cut
Check there is power to the electric socket/appliance
Check the fuse in the plug (Must be 13 amp)
Check that the Temperature Control is set to “1” or above
The compressor runs continuously:
Is the door closed correctly?
Have large quantities of food recently been added to the appliance? – if
yes, allow the interior temperature to recover
Has the appliance door been opened frequently? – if yes, allow the
interior temperature to recover
Check that the Temperature Control has not been set to maximum (“6”)
There is excessive frost/ice build up:
Ensure that the door has been closed correctly
Ensure that the door seal is clean and sealing correctly
Check that the Temperature Control has not been set to maximum (“6”)
The appliance is making a noise:
Refer to Normal Operating Sounds, section 3.4.
Ensure that the appliance has been installed correctly (see section 1).
If after the above checks there is still a fault please contact your retailer.
