=12=
3.1, Sweep function
Sweep frequency, you can set any starting point frequency and end point
frequency in the signal generator output frequency range, sweep time 0.1s~999.9s,
sweep type is linear scan, logarithm scan two scan methods, sweep frequency
direction is positive , Reverse and Round Trip Three Sweep Directions;
➢
In the sweep function (CH1 channel), press the soft key
to select the starting point
frequency, end point frequency, sweep time, sweep direction and sweep mode. After the item is
highlighted, use the arrow keys (or press the soft
－
key
) and the knob to edit the item's
parameters.
➢
After setting all the items, press the soft key
to start the sweep function and press the key
to stop.
3.2. pulse function
You can adjust pulse wave pulse width and pulse period time digitally, which
is more accurate than adjusting the duty cycle;
➢
In the pulse function (CH1 channel), press the soft key
to select the pulse width,
period, offset, and amplitude. After this item is highlighted, edit the item parameters by pressing
the arrow keys (or press the soft key
) and rotating the knob. , pulse width and period units
can be switched between ns and us by pressing the key
when the item is highlighted.
➢
After setting all the items, press the soft key
to start the sweep function and press the key
to stop
3.3. Bursting function
The pulse train can be set to output 1-108575 periods. The burst mode is divided
into internal CH2 channel bursts, external input signal bursts, and manual bursts. It
should be noted that the period time of the burst train is less than the burst signal
period time.
➢
In the burst function (CH1 channel), press the soft key
to select the number of pulses
and the burst mode. After this item is highlighted, use the arrow keys (or press the soft key
) and the knob to edit the item parameters.
