..............
..............
10
11
...........................................................................................................................................................................................................................
The elastomers have different compression
characteristics, and you may find other
combinations of elastomer hardness and pin
position which suit the roads you ride on and
your riding style better; it is just a matter of trying
different combinations. The elastomer system
is simple and small enough that you can carry
a couple of elastomers in your bag and change
them when you are out on a ride if you like.
If you ride on rough terrain or ride aggressively,
you may benefit from a harder elastomer. If you
are a leisurely rider, who rides predominantly on
smooth tarmac, you may be able to use a softer
elastomer. If the setup is too soft/hard the trike
may not reach its optimised comfort setting.
You should generally get a better result with
the hardest elastomer recommended for your
weight, for example if your weight is 90kg use
the green elastomer in position 2 rather than red
in position 4.
If you are a light rider and have your suspension
setup soft it is advisable to adjust it to a firmer
setting; change for a harder elastomer if
necessary before allowing a significantly heavier
rider to sit on your trike, otherwise permanent
damage to the elastomer may occur.
With rear or full suspension, tyres can be run at
higher pressure while maintaining good comfort.
Contrary to popular belief, elastomers do not
significantly change stiffness with lower or higher
temperatures.
The elastomer is removed by pulling and
twisting it off the shock pin. With the back end
hinged open, screw the shock pin into the
required hole in the shock plate. Firmly push the
elastomer back onto the pin and close the swing
arm back onto the stainless steel clip.
The position you have selected using the
table above will give you a good starting point.
Your trike should perform properly like this;
however, it is worthwhile spending a little time
experimenting with settings to find one that suits
you best.
2.2a Suspension adjustment
The front and rear suspension can both be fine-
tuned to work well for you. The rear suspension
can be adjusted by a combination of selecting
one of three different elastomers and five
different fitting positions for the elastomer. The
front suspension can be adjusted by selecting
one of three different hardness elastomers.
All trikes come with medium elastomers fitted
to both front and rear suspensions. Other
elastomers are available for purchase from ICE.
Rear suspension
The adjustment is accomplished by the selection
of elastomers and mounting positions. The
elastomers are available in three hardnesses:
Yellow/Soft, Red/Medium, Green/Hard. There
are five mounting positions; the lowest/closest
to the main pivot (numbered 1 here) will make
the suspension feel softer. The highest/furthest
from the main pivot position (5) will make the
suspension feel harder.To setup the suspension
you will need to select an elastomer and position
it by using the table on page 9.
Elastomer positions
Unclip the rear suspension by pulling the
stainless steel clip on the left hand side over
its pin. The purpose of this clip is to keep the
rear swing arm from dangling when the trike is
picked up; it is only unclipped when changing
the elastomer .