Ice RS26, Руководство оператора и каталог запасных частей

Страница: 10 / 47

10 ICE RS26 / RS28-OB / RS32
OPERATOR MANUAL
BATTERY CHARGING
PREVENTATIVE MAINTENANCE
TANK DRAINING
DRAINING THE RECOVERY TANK
$Q\WLPHVFUXEELQJLVFRPSOHWHGRUZKHQUH¿OOLQJ
solution tank, the recovery tank should be drained
and cleaned.
WARNING: If the recovery tank is not
GUDLQHGZKHQWKHVROXWLRQWDQNKDVEHHQ
UH¿OOHGIRDPRUZDWHUPD\HQWHUWKHÀRDWVKXW
off screen and cause damage to the vacuum
motor.
1. While holding the Recovery tank drain hose
(machine components, #40) upward, remove
the cap and lower hose to drain.
2. Open the Recovery tank cover (machine
components, #18) and rinse out the tank. Use
a rag to remove any excess dirt. Clean the
YDFXXPIDQLQOHW¿OWHUORFDWHGLQWKHUHFRYHU\
tank .
DRAINING THE SOLUTION TANK
Any time scrubbing operation is completed, the
solution tank should be drained and cleaned.
1. While holding the Solution tank drain hose
(machine components, #41) upward, remove
the cap and lower hose to drain.
2. Rinse the solution tank with clean water after
every use. This will help prevent chemical
buildup and clogging of the solution lines.
WARNING: Fire Or Explosion Hazard.
Batteries Emit Hydrogen Gas. Keep Sparks and
Open Flame Away. Keep Battery Compartment
Propped Open When Charging.
8 se on O y apprved chargers Z ith the fo OO o Z ing
speci ¿ cations:
‡
Automatic shut off circuit
‡
Deep cycle charging
‡
Output current of 20-30 Amps
‡
Output voltage of 24 volts
ON-BOARD BATTERY CHARGER
$VVWDQGDUGFRQ¿JXUDWLRQWKHPDFKLQHLVHTXLSHG
with the On-board battery charger. The settings
of On-board battery charger had been set for the
recommended batteries type.
WARNING:
7KH2QERDUGEDWWHU\
FKDUJHUVHWWLQJVFKDQJHDUHWREHFRPSOHWHG
E\DXWKRUL]HGVHUYLFHFHQWHUVRQO\)DLOXUH
WRSURSHUO\VHWZLOOUHVXOWLQWKHEDWWHULHVRU
charger damage.
1. Transport the machine to a well ventilated area.
2. Turn the machine off.
3. If charging wet (lead acid) batteries check the
ÀXLGOHYHOEHIRUHFKDUJLQJ
4. Prop up the Operator seat by the support stand
for ventilation.
5. Connect the charger's AC power supply cord to
a properly grounded receptable.
6. The charger will automatically begin to charge,
you can watching the charging status on the
window (machine components, #7), once the
charging cycle begins, the indicator lights will
progress from red, yellow to green. when the
green indicator light comes on, the charging
cycle is done. Unplug the charger cord.
NOTE: The machine Z i OO can not operate
Z hen charging.
WARNING: Before performing any
PDLQWHQDQFHRQWKHPDFKLQHEHVXUHWKDW
WKHSRZHULVWXUQHGRIIRUWKHEDWWHULHVDUH
disconnected!
:$5,1*5HSDLUVDUHWREHFRPSOHWHG
E\$XWKRUL]HGVHUYLFHFHQWHUVRQO\$Q\UHSDLUV
FRPSOHWHGE\XQDXWKRUL]HGSHUVRQVZLOODYRLG
the warrenty.
DAILY MAINTENANCE
1. Remove pad driver/ brush and clean with
approved cleaner.
2. Drain recovery and solution tanks completely
and rinse out with clean water. Visually check
the recovery tank for debris and clean out as
necessary.
3.
5DLVHWKHVTXHHJHHDVVHPEO\RIIÀRRUDQGZLSH
it down with a damp towel. Be sure to store the
squeegee in the up position.