Ice i36BT, Руководство оператора и каталог запасных частей, Страница: 11 / 46

11 ICE i36BT
OPERATOR MANUAL
To Adjust a Tapered Brush Pattern:
1.Remove the brush door from the brush.
2.Hold the brush plug shaft with a wrench and
loosen the 6mm hex screw.
3.To lower the brush end, turn the shaft clockwise
for the front brush and counter--clockwise for the
rear brush. Retighten hex screw.
4.Recheck brush pattern.
NOTE: Replace brushes when worn to 5/8”
(15mm).
CYLINDRICAL BRUSH MODEL
Install brush:
1. Raise scrub head off the
fl
oor and turn off the
power.(remove key)
2. Remove brush door from scru
E
head by
loosening the knob.
3. Attach brush door to the brush end that has the
double row of bristles to install brush.
4. Check the brushes to ensure they are properly
adjusted.
Inspect the Brush Pattern:
After installing a new set of cylindrical brushes
check the brush pattern to ensure proper brush
adjustment.
1. Measure the distance from the front edge of the
scrub head to the
fl
oor and from the back edge of
the scrub head to the floor.The measurements
should be the same.
2. To level the scrub head, loosen the lock nut and
turn the leveling screw clockwise to lower the rear
of the scrub head or counter--clockwise to lower
the front.
3. Position the machine on a dry dusty floor or
apply a powdered substance, such as chalk.
4.Adjust the speed control knob to "zero"( )
5.Shut off the solution
fl
ow.
6.Pull the control handle bail to create a brush
pattern on the
fl
oor.
7.Raise the scrub head and pull the machine away.
8.Observe the brush pattern on
fl
oor. If the brush
pattern is uneven or tapered, adjustment is
required.