ICE Series
Installation Guidelines
Page 3
Secure the machine on top of the bin or dispenser.
Attach the ice machine to the bin with the mounting straps provided with the bin or dispenser. If the ice machine is to
be mounted on a bin or dispenser other than an ICE-O-Matic, refer to the manufactures instructions for machine
mounting.
If the ice machine is to be stacked on top of another ice machine, a stacking kit will need to be installed. Refer to the
installation instructions included with the stacking kit.
Important!
A water filtration system should be installed with all ice machines. Check the filter manufactures instructions for proper
installation of the filter system.
All water supply lines must be installed per local codes. Use 1/4 inch O.D. minimum on air cooled machines. On
water cooled machines 3/8 inch O.D. minimum tubing must be run to the condenser. The water supply for the ice
making can “T” off from the condenser line using 1/4 inch O.D. minimum tubing. Make 2 coils of extra tubing so that
the machine can be pulled away from the wall if service is needed.
All drain lines must be installed per local codes. The
purge drain should be a minimum of 5/8 inch O.D.
tubing. Condenser drain on water cooled units should
be 3/8 inch O.D. minimum. Drain line fittings on ICE-
O-Matic bins are 3/4 FPT. The bin drain should be a
minimum of 3/4 inch O.D. Cold water drains should be
insulated to prevent sweating.
Warning!
Do not apply heat directly to the back of bin as
damage may occur to plastic parts.
Connect power supply to the terminal block in the
control box or at the rear junction box if equipped.
Ensure the machine is level within 1/8 inch in all
directions.
Remove any shipping or packaging material.
If the machine has a remote condenser, reference
Remote Condenser Installation.
Once the machine has been installed follow the
start-up procedures.
Attach the ice machine to the bin
or dispenser with the provided
mounting hardware.
Warning!
Do not apply heat directly to the
back of bin as damage may occur
to plastic parts.
