Icaro 2000 – Exclusive Sports Helmets
Divo owner’s manual
Page #
9/11
22/02/24
IC2008-01, 2024-EN2
9
Personalization
Removal and reassembly of internal padding
Important: do not use sharp or pointed tools such as screwdrivers, etc., in order to not to scratch or
damage the helmet and its structural components
Divo has a
comfort lining
that can be removed and re-installed in order to personalize the helmet’s fit, or to
wash the lining.
Divo’s
comfort lining,
comprising a cap in
Coolmax
, is fixed to the
polystyrene inner shell by
means of a series of Velcro
strips. It is easy to remove.
Just ensure that you
detach
the Velcro strips by
holding and pulling the
strips themselves. Don’t
just pull the inner cap out
from the helmet
.
Assembly
To assemble the lining, reverse the removal sequence, ensuring that the Coolmax cap is positioned centrally
and symmetrically.
When you are sure that the cap is in the correct position inside the helmet, press firmly over the Velcro
fastening strips in order to fasten the lining.
Visor removal and installation
The visor can be removed if it has to be cleaned thoroughly or replaced, or if you have purchased a new visor
for your Divo helmet.
Important
: when fitting and removing the visor, be careful not to scratch the surface of the helmet or visor with
a screwdriver or other sharp or abrasive objects.
Don’t touch a mirror-finish visor with your hands, because it may be opacified by the acid contained in
perspiration.
Removal of the visor
•
Place the helmet onto a table, ensuring that it is entirely stable, and lower the visor into its position of
normal use.
•
Unscrew the two lateral fixing screws. When the first screw has almost been completely unscrewed,
be careful not to lose the rubber O-ring, positioned inside the aluminium, and the Mylar washers
between the visor and the outer shell.
•
If you decide to fly without a visor, remove all the elements that are not part of the outer shell, and cover
the threaded bushes in the shell using the stickers provided.
•
It may be necessary to periodically replace the rubber O-rings in order to guarantee the correct damping
of visor closure.
Adding or re-installing a visor:
If you bought a visor for your helmet separately, it is supplied with the two screws and separators needed for
assembly.