ICA Duster 3000, Руководство по эксплуатации и техническому обслуживанию, Страница: 3 / 8

Warnings Before Use:
x
The operation of this unit does not exclude the proper use of industry approved
respirators and Island Clean Air Inc. cannot guarantee health benefits.
x
This machine is not to be used in hazardous locations, where explosive,
combustible, corrosive, or conductive dust, vapors, or gases are present.
x
Use of the Duster 3000 without filters or with non-ICA branded filters will void
the warranty.
Duster 3000 Setup Step 1: Uncrate the Duster 3000
x
Remove all WKHVFUHZVIURPWKHIURQWWZR´[´ZRRGHQVXSSRUWXSULJKWVDQG
front wooden panels with a #2 Philips screwdriver or power tool.
x
5HPRYHWKHWZR´[´ZRRGHQVXSSRUWXSULJKWV .
x
Roll the Duster 3000 off the skid.
x
Remove the plastic bag.
Duster 3000 Setup Step 2: Install the Intake Filters
x
Remove the three intake filters from their boxes.
x
Insert the intake filters in front of the preinstalled carbon filters. Make sure that
the black Velcro pull tabs attached to the carbon filters are not pinched
between the filters.
x
Secure the intake filters with the Velcro tabs located on both sides of each filter.
Correct Incorrect
x
Proper sealing of the intake filters will prevent dirty air from bypassing the
metal framed intake filters. Improper sealing will plug up the carbon filters and
the top filter.
Duster 3000 Setup Step 3: Plug in the Duster 3000
x
Locate an electrical outlet that is capable of handling the Duster 3000:
x
110-120Vac, 12A, 60Hz, 1Ph
x
If connected to a circuit SURWHFWHGE\$IXVHVXVHGHOD\IXVHVPDUNHG³'´
x
Make sure your electrical power panel is capable of handling a 12A load in
addition to your current usage. Overloading your panel may not allow the
Duster 3000 to function correctly or to its full airflow capacity.
x
Roll the Duster 3000 into position, plug it in, and turn it on.