Manual IB-RD2253-C31
Usage
•
The RAID enclosure can be connected or disconnected while the computer
is running.
•
Please await the end of read/write operations before disconnecting the unit
to avoid data loss.
•
A new SSD must first be initialized, partitioned and formatted by the opera-
ting system to be displayed by the system.
•
If the drive is not recognized instantly by the operating system, please check:
if the driver software (USB) is installed and up to date.
if the SSD is initialized, partitioned and formatted.
Hint
: The full USB 3.2 Gen 2 transfer rate of up to 10 Gbit/s can only be achieved
with a compatible USB 3.2 Gen 2 port on your host computer.
Set RAID mode
Set the RAID mode according to your individual needs.
Set the RAID mode using the two small slide switches on the back.
Hint
: Use the small screwdriver to move the switches.
1.
set the switch to the desired mode
2.
confirm the setting with the "RESET" button
Note
: The blue LED on the rear panel indicates the current RAID mode.
ATTENTION: After pressing the "RESET"
button all stored data will be lost!
