ic audio GmbH
Boehringerstraße 14a; D-68307 Mannheim; Germany
Fon: + 49(0) 621 / 77096-0; Fax: + 49(0) 621 / 77096-26
E-Mail: [email protected]; www.ic-audio.com
EN
5
ic audio
1
.
All/Zone 1~6 select switch & LED.
※
All” switch can activate Zone 1~6 of MT-AMP 1000 and the relative Zone LED will light up.
Zone 1~6 switch can select each zone individually.
When the zone is selected, the relative LED will light up.
Press again to disable the Zone output.
2
.
Source/Aux 1~3 select switch & LED
Once the BGM signal selection of MT-AMP 1000 is set at “Remote” position, the wall panel can take over
BGM of MT-AMP 1000.
※
Source” is to select signal from music source module of MT-AMP 1000.
※
Aux 1~3” is to select signal from Aux 1~3
The LED will light up when the signal is selected.
3. LINE IN
耳
3.5 LINE IN socket can input external music signal.
Line in signal will mix with MIC Input.
The priority is the same as BGM of MT-AMP 1000.
4. MIC Input
Balanced MIC Input can give speech to MT-AMP 1000 through MT-WCP-6 .
The priority is lower than MIC 1~6 but same priority as Source/Aux 1~3 of MT-AMP 1000.
5
.
Mix level adjust VR
The Line In and MIC signal will mix together.
The mixed signal level can be adjusted by “Mix Level” trimmer.
6
.
Remote Master VR
Remote Master VR can adjust the MT-AMP 1000 Master volume level.
When BGM is set at “Remote”, it can take over the Master volume control of MT-AMP 1000.
7. Activate Switch
Push Switch to switch on the wall panel, the activate LED will light up.
The wall panel will able to control MT-AMP 1000.
Push again to switch off wall panel, the activate LED will light off.
The LED will flash in 200mS periodically when there is other higher priority signal is operating.
The LED will flash in 1 Sec periodically if the BGM of MT-AMP 1000 is not set at “Remote” position.
MT-WCP-6
