Performance curves
-3-
-2-
2.lnstallation
3.Pipe Assembly
4.Electrical connection
EN60335-2-41
5.Controls Prior to Initial Start-up
6.Start-up
7.Maintenance and clean
Our pumps for hydromassage facilities do not require any special maintenance or programming.
If the pump will be idle for a long period of time, it is recommended to disassemble, clean and store
it in a dry, well-ventilated place. If the supply cord is damaged, it must be replaced by the manufacturer or its
service agent or a similarly qualified person to a hazard.
Pump can be automotive empty water after correct installation.
When the pump needs to clean (1) filling with water up to level position of bathtub`s nozzle, (2) operating
2-3mimute,(3) exhausting water of bathtub after engine stop.
-Is the proper voltage applied to the pump?
-Is there an extension cord being used?
-Jets should be pointed away from the suction
inlet so air is not forced into pump suction
-Is the in-tub suction inlet blocked or covered?
-Is there any debris in the pump housing?
-Is there a leak in the piping or the pump?
-incoming power to the pump?
-Is circuit breaker on?
-Is GFCI operating properly?
-Is the air switch plugged in?
NO POWER
TO PUMP
PUMP DOES
NO TURN
BLOCKAGE OR
LEAK
LOW VOLTAGE
PUMP NOT
PUMPING
PROPERLY
SYMPTOM
POSSIBLE CAUSE
CHECK
8.Trouble Shooting Guide
H
e
a
d
0 50 100 150 200 250 300 350 400 450
0 3 6 9 12 15 1 8 21 24 2 7
0 20 40 6 0 80
0 20 40 60 80 100
20
16
12
8
4
0
30
25
20
15
10
5
0
60
50
40
30
20
10
0
H
(psi)
H
(m)
H
(ft)
SWIM150
SWIM100
SWIM050
SWIM075
U
. S.GPM
IMP.GPM
3
m /h
l/min
Flow
SWIM025
SWIM035
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, orlack of experience and knowledge, unle-
ssthey have been given supervision or instruction concerning use of the app liance by a
person responsible for their safety. children should be supervised to ensure that they do
not play with the appliance.
ype x attachment with specially prepared cord damaged supply cords must be replaced
T
by a special cord or assembly available from the manufacturer or its service agent.
ype y attachment damaged suppl y cords to be repl aced by the manufacturer, service
T
agent or similarly qualified person to avoid hazard.
ype z attachment damaged supply cord cannot be replaced and the appliance shall be
T
scrapped.