IBM xSeries 440 8687, Руководство по техническому обслуживанию аппаратной части

Страница: 46 / 258

These procedures assume that you have an operational keyboard and pointing
device attached to the server.
Enabling remote access to the adapter: The Remote Supervisor Adapter
requires configuration to enable remote access through either the Ethernet port or
the serial port. From Table 3, choose the interface method that you want to use to
perform remote management; then, perform the indicated configuration procedure.
Note: For detailed information about using the ASM Web interface and the
text-based user interface, see the Remote Supervisor Adapter User’s Guide
on the IBM Documentation CD .
Table 3. Configuration tasks to enable remote access to the Remote Supervisor Adapter
User interface to Remote
Supervisor Adapter
Connection to Remote
Supervisor Adapter
For the configuration
procedure, see:
ASM Web interface using
the HTTP protocol
LAN using the Ethernet port “Configuring the Ethernet
settings for Web-based remote
access”
Text-based user interface
using the TELNET protocol
Text-based user interface
using a modem or a null
modem
Serial (COM) port “Configuring the serial port for
text-based remote access” on
page 36 and “Setting up
point-to-point protocol” on page
37
ASM Web interface using
point-to-point (PPP)
protocol
Text-based user interface
using the TELNET protocol
over PPP
Configuring the Ethernet settings for Web-based remote access: If you have an
accessible, active, and configured dynamic host configuration protocol (DHCP)
server on the network, the hostname, IP address, gateway address, subnet mask,
and DNS server IP address are set automatically. You do not need to perform
further configuration tasks to enable the Ethernet connection because the default
value for the DHCP Setting field is Enabled. If you need to configure the serial port,
go to “Configuring the serial port for text-based remote access” on page 36;
otherwise, go to “Configuring the remote control password” on page 40.
If you do not have a DHCP server on the network, complete the following steps to
configure the Ethernet settings.
1. With the server turned off, insert the diskette with the downloaded utility
program into the diskette drive; then, turn on the server.
2. The utility starts automatically, displaying the Remote Supervisor Utility
window.
3. Use the Up Arrow and Down Arrow keys ( ↑ and ↓ ) to select Configuration
Settings ; then, press Enter. The Configuration Settings window opens.
4. Use the arrow keys to select Ethernet Settings ; then, press Enter.
The Ethernet Settings window opens, as shown in the following illustration.
34
xSeries 440 Type 8687: Hardware Maintenance Manual