IBM xSeries 100, Руководство по диагностике и обслуживанию

Страница: 88 / 126

Removing a drive in bay 4 or 5
To remove a drive from bay 4 or 5, complete the following steps.
Locking lever Screws
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 55.
2. Turn off the server and all peripheral devices; then, disconnect the power cords
and all external cables.
3. Remove the cover (see “Removing the cover” on page 57).
4. Disconnect the cables from the drive to be removed or from both drives in the
drive cage, if two drives are installed.
Attention: Make sure that you do not hit the microprocessor fan sink when
removing the drive cage.
5. Remove the drive cage:
a. Move the locking lever on the drive cage to the Unlock position.
b. Firmly grasp the drive cage and slide it toward the rear of the server until it
disengages from the chassis.
c. Lift the drive cage out of the server.
6. Remove the four screws (two on each side) that secure the drive to the drive
cage and slide the drive out of the cage.
7. If you are instructed to return the drive, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.
72
IBM xSeries 100 Type 8486: Problem Determination and Service Guide