IBM WebSphere DataPower XC10, Руководство по установке

Страница: 25 / 52

Power supply modules
The WebSphere DataPower XC10 appliance is powered by two fully redundant 650
watt power supply modules. A single power supply module can supply enough
power to support appliance operations. The power supply modules can be
hot-swapped, which means that you can replace a single power supply module
without powering down the appliance.
Each power supply module contains two fans. Failure of at least one fan causes the
power supply module to overheat and generate messages.
At the rear of the appliance, each power supply module has an LED light that
indicates its operational state.
Data storage unit
The WebSphere DataPower XC10 appliance comes with the hard disk array to
provide data storage. The hard disk array is part the hard disk drive module. This
module include two 146 GB disks in a RAID 1 configuration and includes two
fans. The disks operate as a single, mirrored volume. The disks cannot be used as
two discrete disks.
You need to replace the hard disk drive module if one of the fans becomes
inoperable. A replacement hard disk drive module does not contain the disks. For
a replacement hard disk drive module, you use the existing disks. If an individual
disk becomes inoperable, you can replace that disk.
LED diagnostics panel
The rear panel of the WebSphere DataPower XC10 appliance includes an LED
diagnostics panel with six LED lights. The layout is three LED lights in two rows.
HDD
fan
Drive 0 Drive 1
Battery Fan 2 Fan 1
Table 3 shows what each LED light represents.
Table 3. LED diagnostics panel
Position of light Meaning
Top row, left The state of the fans in the hard disk drive
module
Top row, center The state of the Drive 0 hard disk
Top row, right The state of the Drive 1 hard disk
Bottom row, left The state of the battery
Bottom row, center The state of the fans in the fan module 2
Bottom row, right The state of the fans in the fan module 1
Chapter 1. Introduction
5